Alton STANLEY 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Alton STANLEY에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alton STANLEY 14 페이지. 23 litre wet/dry vacuum

OPERATING INSTRUCTIONS

UNPACKING & SET-UP SUMMARY

1. Pull lid latches in an outward motion, remove power head and some accessories that may have

been shipped in the tank.

2. Attach the casters according to the instruction in this manual.

3. Before replacing power head, refer to this manual to ensure you have the proper filters installed

for your cleaning operation.

4. Replace power head, and apply pressure with thumb to each latch until it snaps tightly in place.

Make sure all lid latches are clamped securely.

5. Insert the flexible hose end into inlet of tank.

6. Attach the extension wands to the accessory end of the hose. Apply slight pressure until fitting

is tight.

7. Attach one of the cleaning accessories (depending on your cleaning requirements) on the

extension wands. Twist slightly to tighten the connection.

8. Plug the cord into the wall outlet. The vacuum is ready for use.

CASTER ASSEMBLY

Insert casters into dolly and snap them into place.

WARNING:

To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases,

vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to:

lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive

dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not

vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vac as a

sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors

or dusts, do not vacuum toxic materials.

WARNING:

The operation of any utility vac can result in foreign objects being blown into the eyes, which can

result in severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 in USA or

CSA Z94.3 in Canada before starting operation.

CAUTION:

To reduce risk of hearing damage, wear ear protectors when using the vac for extended hours or

when using it in a noisy area.

This vac is assembled at the factory and ready for use when you remove it from the carton. The

unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall receptacle,

turn the unit "ON" by pushing the switch from position "O" to position "I". The "O" is the "OFF"

position and the "I" is the "ON" position.

O = OFF I = ON