Altor ATDAC-10S 사용자 설명서 - 페이지 6
{카테고리_이름} Altor ATDAC-10S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Altor ATDAC-10S 8 페이지.
Using external amplifier control:
ATDAC-10S have galvanic isolated digital (dry contact, i.e. - open collector) output which
is dedicated to control the external amplifier. Dry contact is closed (short) if ATDAC-10S
is not in standby. 3.5mm Jack is used for connection.
See below the electrical schematic of this output.
Cable recommendations:
Use only high quality cables according your preferences and possibilities!
Specially pay attention to the input cables:
USB cable: - do not use thin and very long cables. 0.5-1m is the reasonable length.
SPDIF cable: not all regular interconnect RCA cables are capable to operate in high
frequencies.
Optical TOSLINK cable: not enough quality cable may not operate in 192kHz or even at
96kHz sample rate. Also for some cheap cables degradation with time (aging) was
observed.
©2018.
10R
1
4
2
®Altor Co
3
4
2
5
1
6
Altor
A U D I O
Netanya, Israel