ClearSounds ClearBlue 사용자 설명서 - 페이지 11
{카테고리_이름} ClearSounds ClearBlue에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSounds ClearBlue 17 페이지. Bluetooth tv & audio listening system
페이지 인쇄Pair
c.
Plug in the
(
) on the sound-emitting device.
Troubleshooting: If pairing is unsuccessful, the headset
goes into standby mode after two minutes, and the
transmitter goes into standby mode after one minute.
•
If the headset is paired and actively connected to
another device, turn off Bluetooth in that device,
and then try again to pair with the desired device.
Check the device user's guide for these topics:
•
The ClearBlue headset can pair only with devices
that have the Bluetooth pairing password set to 0000.
•
Some devices require additional steps for
Bluetooth pairing.
To pair with a
You can pair the ClearBlue headset with a mobile
phone that has a built-in Bluetooth HFP or A2DP
profile.
If necessary, consult the mobile phone user's guide
for more specific instructions regarding the phone's
Bluetooth menus.
18
to an audio-out port
1.
Hold the
within three feet of the mobile phone.
2.
On the
, press and hold
seconds, until the red and blue lights blink
alternately.
The headset is in pairing mode, which lasts for
about two minutes.
3.
Within two minutes, on the mobile phone:
a.
Open the Bluetooth menu.
b.
Turn on Bluetooth.
c.
Initiate adding a new device.
d.
Select ClearTV in the device list.
e.
If prompted for a PIN number, enter 0000, and
then follow the prompts.
When the red light stops blinking and the blue
light blinks twice every four seconds, the head-
set is paired with the device.
Troubleshooting: If pairing is unsuccessful after two
minutes, the headset goes into standby mode.
•
If
is on nearby, or if another device is con-
nected to the headset nearby, turn off
the other device during mobile phone pairing.
•
Turn off and on the headset, and then try again.
for seven to nine
or
19