ClearSpan 104510 사용 설명서 - 페이지 11
{카테고리_이름} ClearSpan 104510에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 104510 15 페이지. Frame 20' wide x 20' long
페이지 인쇄SQUARE THE ASSEMBLED FRAME
Complete these steps:
1.
Square the frame by measuring diagonally corner-
to-corner at ground level and align all legs as shown
below. The frame is square when the two diagonal
measurements are equal.
TOP VIEW
2.
Continue by anchoring the frame.
Revision date: 07.01.08
CLEARSPAN
ANCHOR THE FRAME
Once the frame is anchored properly, continue with these
instructions.
WARNING: Securing the rafter mounting feet (if
equipped) to baseboards set on the site is not a
substitute for properly anchoring the shelter. You must
anchor the shelter as described in the MUST READ
document.
FAILING TO PROPERLY ANCHOR THE SHELTER
WILL RESULT IN DAMAGE TO THE SHELTER AND
MAY CAUSE PERSONAL INJURY.
READ THE MUST READ DOCUMENT TO PROPERLY
ANCHOR THE SHELTER.
After anchoring the frame, check the frame for rough
edges as described in the following procedure.
FINAL FRAME CHECK
1.
Return to the frame connections and verify that all bolts
are tight. Position bolt heads toward the cover.
2.
Verify that all bolts have been inserted in the first/
outermost holes of the coupler fittings.
3.
Verify that each rafter splice is secured with a Tek
screw.
4.
Verify that each Tek screw is positioned with its head
away from the outside of the frame. Duct tape may be
used on the Tek screws to protect the cover.
5.
Inspect the frame for sharp areas that could damage
the cover. If found, file smooth and cover with layers of
duct tape to protect the cover.
6.
Verify that all bolts are positioned with the heads to the
outside of the frame. Tape the bolts and rafter joints
before installing the cover.
7.
Continue by installing the main cover.
JUBILEE TENTS
™
11