Bambi MD35/20 운영자 핸드북 매뉴얼 - 페이지 4
{카테고리_이름} Bambi MD35/20에 대한 운영자 핸드북 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bambi MD35/20 20 페이지.
페이지 인쇄
2
Operation
Refer to exploded parts diagrams and illustrations when reading this section.
Oil level
Your Bambi compressor is shipped without oil for transit. Before use you must fill the
motor to the correct level.
Model 35/20
•
Remove oil filler plug - see fig 1
•
Pour oil into motor until correct level is reached - indicated on the oil sight glass,
approx 500cc - see fig 2
•
Refit the oil filler plug - but do not over-tighten.
•
Models 75/80 to 225/1000
•
Remove air intake filter housing by pulling gently out of intake tube - see fig 9
•
Pour oil into motor through the tube until the correct level is reached indicated on
the oil sight glass, approx 900cc - see fig 2
•
Refit air intake filter to intake tube
Note!
Always use Bambi SB42/46 compressor oil. Failure to do so will invalidate your warranty.
Starting & Stopping
Plug the compressor into an outlet socket of nominal
voltage and fitted with a 13amp fuse.
Note!
Model 225/1000 requires a dedicated 20 amp power supply.
Switch the compressor on using the red button on top of the pressure switch. Pull
knob up to switch on, push down to switch off – see fig 3.
The compressor will start running and automatically switch off at the preset pressure.
As air is used the pressure drops and the motor will restart at the preset pressure.
Approx 2 Bar differential.
Note!
Never tamper with the pressure switch settings, these are factory set.
Adjusting Outlet Pressure
Use the filter regulator to adjust the outlet pressure. The 40mm pressure gauge
indicates the selected pressure. To increase line pressure rotate the black knob on
top of the filter regulator in a clockwise manner, to decrease turn anti clockwise. It is
possible to lock the setting by pushing the knob down until it "clicks" home – see fig 4.