Altra Industrial Motion Warner Electric PB-400 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Altra Industrial Motion Warner Electric PB-400에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altra Industrial Motion Warner Electric PB-400 18 페이지. Primary brakes

페이지 인쇄

Send Quote Requests to [email protected]

Step 2

Fasten bracket (1) to clutch field/brake magnet with one

No . 10-32 hex washer head screw (2) . The screw is self-

tapping, threads are not

provided in the magnet bracket adapter . The square

projection on the magnet fits into the square hole in the

bracket . The curved side of the bracket mounts toward

the magnet . The bracket flange is toward the flange side

of the magnet . (See Figure 11)

Step 3

Mount conduit box to bracket . The conduit box flange

must be toward flange side or the magnet (rear of

bracket) . Thread terminal spacers into field/magnet

before fastening conduit box to bracket . Do not over

tighten, excessive torque will pull thread insert out of

magnet/field . Secure conduit box to bracket with two

No . 10-32 hex washer head screws (4) . (See Figure 12)

Warner Electric • 800-825-9050

Figure 11

Figure 12

Send Quote Requests to [email protected]

Call +1(800)985-6929 To Order or Order Online At Warnerelectricparts.com

Step 4

Connect electric supply cable to the fitting installed on

the conduit box . If an external power supply is furnishing

DC current to the clutch or brake, proceed to Step 5 and

skip Step 6 . If a Warner Electric CBC-100 power supply

is being installed in the conduit box, skip Step 5 and

proceed to Step 6 .

Step 5 - DC Connection

Slide one terminal cap (8) onto each of the two supply

conductors, small end first . Connect the two supply

conductors (with rubber caps) to the magnet or field

terminals using two No . 8 brass screws (11) and ring

terminals (9-1) . The stripped wires can wrap around the

screw between the terminal ring and the screw head

or other ring type terminals may be used . Electrical

supply connections must conform to local electrical

codes . Install plug (12) into cover hole .

Step 6 - AC Connection

When a CBC-100 power supply is used, refer

to installation sheet P-266 provided with the CBC-100,

following instructions carefully . To mount the CBC-100 to

the conduit box, place the control into the cover so the

curved surfaces conform, line up the cover hole with the

control mounting hole and fasten with screw provided

in the mounting kit . Connections to the magnet or field

terminals are as outlined in Step 5 .

Step 7

A ground wire is recommended for grounding of the

conduit box and brake magnet or clutch field . Connect

this wire with the green ground screw (9) to the hole in

the bottom of the box . Consult electrical local codes

regarding grounding requirements .

Step 8

Install cover (10) by sliding the slot in the cover over the

tab on one end of the conduit box and secure the cover

on the opposite end with one No . 10-32 hex washer

head screw (11) .

P-201-WE • 819-0480 7