ClearSpan R035A00007 매뉴얼 - 페이지 6
{카테고리_이름} ClearSpan R035A00007에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan R035A00007 11 페이지. Corrugated polycarbonate end panel kit 30' wide & 35' wide
페이지 인쇄END PANEL INSTALLATION (continued)
5.
Secure the panel to the end frame girt using Tek
screws and neo-bonded washers inserted every 6" or
so (see drawing A).
Do not install Tek screw into the valley where the next
panel overlaps the first. See diagram B.
6.
Select another 50" x 12' 2"
overlapping the first panel by one (1) rib as shown in
drawing B. Do not attach at this time.
7.
Holding the panel in place, repeat steps 2 through 5
to mark, trim, and attach panel to the end frame. DO
NOT attach the panel to the top girt at this time. See
diagram below.
NOTE: Leave the innermost valley open for the
installation of the next panel; panels overlap by one
(1) rib. See diagram below for girt positions.
8.
Continue attaching 50" x 12' 2" panels in this fashion
until the bottom row of end panels is complete. Cut
the final panel to fit as needed.
Remember to account for the installation of the
sidewall panels if equipped. Position and cut final
panel as needed.
Actual end frame and panels may differ from frame
shown. Consult the panel diagrams located in the
Quick Start section for the end kit ordered.
Trim
excess panels
B
A
6
End Panel Installation
panel and brace it in place,
50" x 12' 2"
50" x 12' 2"
panel
panel
Girt
Ground Level
A
Girt
Corrugated Panel
Valley
B
Girt
No Tek screw in
this valley.
Rib
Do not attach panels to the top girt. Tek
screws are installed after the top panels
are set into place. Top panels overlap
lower panels. Typical overlap is 6".
TOP VIEW
TOP VIEW
Corrugated Panel
No Tek screw in
this valley.
Trim
excess panels
Revision date: 04.13.09