ClearSpan R035B00011B 매뉴얼 - 페이지 11

{카테고리_이름} ClearSpan R035B00011B에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan R035B00011B 15 페이지. Greenhouse door kits

페이지 인쇄

DoubLe CoRRuGATeD DooR ASSeMbLY (continued)

Install sections of the horizontal closure strips (104709)

under the panel before attaching the panel to the door

frame. Trim closure strips as needed.

Drive Tek screws and washers through the panel,

closure strip, and into the frame every 6" or so. Install

Tek screws and washers in the valleys of the panel.

Screws should be snug. Do not overtighten screws.

Latching

Door Latch

Attach the panel in the locations as shown to hold

Plate

the panel in place. If needed, secure the sides of the

Guide

polycarbonate panel to the door frame using Tek screws

only every 16".

Attach the

door latch guide to the door frame using the

remaining 1/4" bolts. Trim the edge of the corrugated

panel as needed to allow free movement of latch.

10.

Repeat the required steps needed to assemble the

remaining door frame and installation of the panel.

Horizontal

Position

11.

With assistance, set the assembled doors in the end

wall door frame and secure hinges to the door jamb

using one Tek screw per hinge at this time.

NoTe: Verify that there is sufficient clearance along

all door edges to allow the doors to swing freely in the

opening. If end panels are installed, loosen the panels,

secure the hinges directly to the door jamb, and reinstall

panel fasteners.

12.

Test the operation of the doors, adjust hinges as

needed, and install the remaining Tek screws to secure

hinges.

Closure Strip

STEP 6

Revision date: 05.28.10

Corrugated Double Swinging Doors

Valley

Tek Screw

and Washer

Closure Strip

104709 strip

STEP 9

Latching

Door Latch

Plate

Guide

Horizontal

Position

STEP 13

Trim corrugated panel as needed

to install the door latch guide.

STEP 7

STEP 8

Closure Strip

STEP 11