3G Audio AK800 사용자 설명서 - 페이지 3

{카테고리_이름} 3G Audio AK800에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3G Audio AK800 9 페이지. Four channel power amplifier

FOUR CHANNEL POWER AMPLIFIER

1 Introduction

AK800 amplifier has been designed using an advanced structural concept and qualified components

to meet the most demanding requirements in the sound amplification field.

The AK800 amplifier has four independent channels:

Right channel

Center channel

Left channel

Subwoofer channel

500W

150W

Before connecting the amplifier to the power socket, make certain that the voltage corresponds

with that indicated on the rear of the unit. (a tolerance of

10% is acceptable).

Before connecting the power cable to the mains, always make certain that it is not damaged and that

there are no bare wires, always connect the power cable to the amplifier before switching it on and only

remove the cable after switching it off.

3. Inputs

There's a XLR connector for each channel respectively on the back panel of AK800.

4. Outputs

Each channel has a NL4 connector and a binding post connector connected in parallel. Only

loudspeakers within the amplifier's declared power and impedance load range should be connected to

the amplifier's output. The red binding posts are considered as hot , connecting to the positive poles

of loudspeakers, the black binding posts connecting to the negative poles of loudspeakers.

5. Power Supply

Make sure power capacity of power outlet is correct. The AK800 amplifier power requirement is:

220V/AC, 12A FUSE.

There are 4 hidden volume controls for each channel respectively.

Do not attempt to service the products beyond that described in the manual. All other serviceable should be referred to

qualified service personnel.