Altrad Belle RTX 60 운영자 매뉴얼 - 페이지 12

{카테고리_이름} Altrad Belle RTX 60에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altrad Belle RTX 60 15 페이지.

페이지 인쇄

Problem

Engine will not start

Engine stops suddenly, or stops

when the engine rpm is increased.

Engine runs, but machine does not

produce impact.

Maintenance

The Altrad Belle RTX

maintenance listed in this section is carried out.

It is recommended that an approved Altrad Belle dealer carries out all major maintenance and repairs. Always use genuine Altrad Belle

HT lead from the sparkplug.

Always set the RTX

Servicing the Engine

Yanmar L48 Engine Priming

below instructions.

CAUTION

the tank.

2. Slide the Engine Speed Control Lever to the RUN position.

Injector Pipe Nut (Item 2).

4. Slacken the Injector Pump Nozzle (Item 3) by 2 full revolutions

NOTE:- DO NOT remove the Injector Pump Nozzle.

5. Hold the Injector Pipe away from the Injector Pump Nozzle and wait until

Diesel is running freely without any air bubbles.

6. Re-tighten the Injector Pump Nozzle to a setting of 12Nm.

section of this manual.

Trouble Shooting Guide

Cause

No fuel

Fuel Tap has been closed

Engine not primed. (GX100 Only)

Engine not primed. (Diesel Only)

Spark Plug contaminated or damaged.

(Petrol Only)

Faulty Carburettor. (Petrol Only)

See Above

Main jet of the Carburettor clogged with

dirt. (GX120 Only)

Spark plug cap is loose. (Petrol Only)

Lack of engine power

Clutch is slipping

Crank mechanism is damaged

Service & Maintenance

(Item 1) by loosening the

Remedy

Fill Fuel Tank

Open fuel tap.

Push the Carburettor Primer Bulb 4 times and

See the Service & Maintenance section of this

Manual.

Replace spark plug.

Service the Carburettor

See Above

Take out the main jet of the Carburettor and

clean with Compressed air.

Clean the element.

See above.

drum with proper solvent. Replace clutch

shoe if necessary.

Contact Dealer.