ClearSpan 6080SS1 사용 설명서 - 페이지 8

{카테고리_이름} ClearSpan 6080SS1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 6080SS1 18 페이지. Add-a-bay shade system

페이지 인쇄

CLEARSPAN

SUNBLOCKER SYSTEM

™

LEG ASSEMBLY

Each leg assembly consists of one (1) drilled pipe, one (1)

5-way coupler, and required cap screws or bolts.

Gather the parts:

•

Drilled leg pipe (#2375120D) and 5-way coupler

(#103839)

•

Cap screw 3/8'' x 1'' (#FAG355B) and band clamp

(#103856)

1. Insert the plain end of a drilled pipe into the bottom

(odd) port of a 5-way coupler.

2. Secure the pipe in the 5-way coupler using 3/8'' x 1''

cap screws through the threaded holes of the coupler.

Cap Screws

(#FAG355)

NOTE: Install the drilled pipes with the plain end

inserted into the 5-way coupler. The drilled end of the

pipes are attached to ground posts or mounting feet if

used.

3. Assemble the legs until all drilled pipes and 5-way

couplers are used.

4. Slide a band clamp onto each leg assembly and

position it near the 5-way coupler. Slightly tighten the

band clamp or use tape to keep it in place.

NOTE: If *mounting feet are used, attach a foot to each

leg assembly using bolts and nuts at this time.

If *ground posts are used, drive the post into the

ground so the top of the post is 1' foot above the

finished grade. Refer to the MUST READ document

sent with the shelter. Use the Quick Start diagrams to

properly space the ground posts if used.

*Additional purchase required for mounting feet and

ground posts.

Visit www.ClearSpan.com for additional products and customer assistance.

RAFTER ASSEMBLY

The leg assemblies are connected with plain pipes to form

the rafters.

Gather the parts:

•

1. Select a plain 20' purlin assembly and slide two (2)

2. Slide each end of the purlin assembly into the through

5-Way Coupler

(#103839)

Leg Pipe

(Plain End)

3. Verify that the on-center width dimension measured at

4. Secure the plain pipe to the couplers using 3/8'' x 1''

5. Reposition the band clamps (previously installed on

Leg assemblies

20' purlin assemblies

Cap screw 3/8'' x 1'' (#FAG355)

Strut (#103838) and band clamp (#103856)

band clamps onto the pipe. This pipe connects two (2)

leg assemblies.

ports of the 5-way couplers as shown below and align

the pipe ends with the center of the 5-way coupler.

Rafter Assembly

Band Clamp

20' Purlin Assembly

Through Port

Leg Assembly

NOTE: Position the 5-way couplers so the through tube

is aligned with the width of the frame.

the 5-way couplers is 20'-3". Adjust as needed.

cap screws through the threaded holes of each coupler.

each rafter leg and the 20' rafter pipe) approximately

12" from the 5-way couplers.

NOTE: If the band clamps were not installed, install

them now. Use adjustable pliers to squeeze the clamps

back into shape after adding them to the pipes.

20'-3"

on-center

Revision date: 10.09.07