Diy Blinds Zebra 설치 지침 - 페이지 3

{카테고리_이름} Diy Blinds Zebra에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Diy Blinds Zebra 4 페이지.

To adjust head rail extension, remove the shade from the

mounting brackets by pressing on the plastic tabs at the

front of each bracket. Then loosen the nut and bolt, and

move the mounting brackets forward or backward as

preferred.

Step 3: SECURE thE HEAD RAIL

Slide the inner rear of the head rail onto

the metal tabs at the back of each bracket,

and then push up so that the brackets

snap onto the head rail.

IMPORTANT FINAL STEP TO PROPERLY SECURE BRACKETS: Pull the plastic tab on the front of each

bracket outward toward the front of the shade to lock the brackets in place. For inside-mounts use pliers to

grasp the tabs. Check carefully to assure that each bracket is properly secured

Step 4: INSTALL THE TENSION DEVICE

A. Lower the shade.

B. Hold the Tension Device upright so the Warning Tag hangs straight

down as shown in diagram.

C. Position the Tension Device on the window frame or the wall so that

the Tension Device and control cord do not interfere with raising or

lowering the shade. The Tension Device should be installed without

stretching or pulling down on the control cord. Stretching the cord will

cause excessive wear. Do not twist or cross the control cord. If using

stop balls, position the Tension Device 1/4 inch higher to allow the stop

ball to pass through the Tension Device.

D. Holding the Tension Device upright, and in position, as shown, insert

and secure the screw through the hole. The mounting screw must be

secured into a solid surface or molly.

ZEBRA

INSTALLATION INSTRUCTIONS