Edgewater Networks EdgeMarc 250W 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Edgewater Networks EdgeMarc 250W에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Edgewater Networks EdgeMarc 250W 7 페이지. Enterprise session border controller
Edgewater Networks EdgeMarc 250W에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (19 페이지), 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

Step 1 − Connecting the Cables

1. If you are using an ADSL connection, connect one end of the phone cable to the ADSL

port (denoted by "A" in the above diagram) and the other end of the cable to the phone

jack on the wall.

Important: No DSL Filter should be installed on the line.

Note: The DSL/Line port also supports an FXO connection. Your connection to the

PSTN can be tested by attaching a phone to FXS port 4 and disconnecting the 250W

from its power source.

2. If you are using an Ethernet connection, connect one end of the Ethernet cable to the

Ethernet WAN port (denoted by "B" in the above diagram) and the other end of the

Ethernet cable to an Ethernet port on a router or a modem.

3. Plug one end of the power adapter into an AC outlet and the other end into the power

receptacle on 250W, denoted by "D" in the above diagram.

4. Connect one end of an Ethernet cable to local LAN port 1 of the 250W denoted by "C" in

the above diagram. Connect the other end of the cable to your computer's Ethernet port.

Instructions

Page 2 of 7