ClearView CleanCam 1006 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} ClearView CleanCam 1006에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView CleanCam 1006 5 페이지.

Pedal Configuration (if applicable):

Each pedal is programmed to perform multiple actions, depending on the step in the workflow.

1. Left Pedal

a. Take Picture

b. Keep and Take Another Picture

c. Yes (attribute dose to X person)

2. Center Pedal

a. Keep Picture

b. Submit for Mid-Prep Review

c. No (attribute dose to X person)

3. Right Pedal

a. Discard Picture

b. Submit for Final Review

Though the pedals are pre-programmed, you may customize the pedal actions. To do so:

1. Press and hold the left pedal.

2. Plug the USB cord into a USB port on the computer.

3. When the light on the pedal starts blinking, release the left pedal.

4. Once the computer recognizes the pedal, open the drive and run the Windows programming

application.

5. Set each pedal to the desired action or combination of actions.

6. Save the configuration.

7. To use the pedal, unplug the USB connection and plug it back in without pressing any pedals.