Altrad Belle POKER Lombardini 15LD225 운영자 매뉴얼 - 페이지 8

{카테고리_이름} Altrad Belle POKER Lombardini 15LD225에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altrad Belle POKER Lombardini 15LD225 8 페이지.

Note:- Before carrying out any dismantling ensure that the machine is switched off.

Drive Dog Housing

To remove the drive dog housing, remove all four bolts (4), the drive dog housing should slide off. Remove the grub screw (6) from

the drive dog (3) and the drive dog should slide off. Re-assembly is opposite of the above.

Engine Oil

To replace the oil within the engine unscrew the bolt in the sump as shown (A) and allow the oil to drain out.

To check or re ll oil use the grey or black plastic bung (B) the oil level should be just to top of the bung hole. Re ll with 10W 30

engine oil.

Air Filter

To check or replace the air lter remove the wing nut on top of the black air lter cover, once this is removed, remove the second

wing nut to remothe air lter (As shown below)

Spark Plug

To check or replace the spark plug remove the HT lead by pulling this away and remove the spark plug.

To check the spark plug, re t the plug into the HT lead and hold the spark plug against the body work of the engine and pull the

engine over by the recoil. (As below) Re-assembly is opposite of the above.

Resetting the Engine Speed

Note:- When checking or resetting the engine speed, do not exceed 2800RPM.

To set the engine speed loosen the stop screw bracket (C) and pull back, start the engine and turn the screw (D) up or down to

increase or decrease the engine speed. Once 2800 RPM has been achieved shut the engine down. Hold the throttle level in the

maximum rev position and push the stop bracket back to this and screw back down.

Spark Plug

& HT lead

Servicing

Recoil

Starter