ClearView POWER SLIDE 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} ClearView POWER SLIDE에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView POWER SLIDE 16 페이지.

Assembly Instructions

Getting power to the Power Slide™

Locate the wiring adaptor on the back of the

Power Slide™, undo the twist tie that keeps

the wire neat, and release the wiring.

IMPORTANT - If you are running the Anderson Plug power supply from the vehicle

to the Power Slide™, you need to secure the Power Slide™ to your vehicle before

the next step, as you will need power to extend the actuators and place the clevis

pins and clips in.

Before extending the actuators, ensure to remove actuator cable away from the

scissor arm area (both sides) to avoid jamming/damaging the actuator wires.

The power supply needs to be a minimum 15 Amp with a 6mm cable.

Refer to Page 11 for 'Positioning and Mounting your Power Slide™.

Running the actuators into position

Use the UP direction on switch to run the actuators up along the actuator ramps.

NB: The switch is located on the front of the Power Slide™

Slowly guide and drive the actuators into position, the actuators will run and turn over.

As you get close, slowly guide actuator until you get to the right position.

Please be mindful to keep your hands and body safely away from the actuators/any

moving parts to avoid getting caught etc.

clearviewaccessories.com.au