ClearView PowerBoards PB -TA-004 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} ClearView PowerBoards PB -TA-004에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView PowerBoards PB -TA-004 16 페이지. Toyota land cruiser 79 series 1984 - current

페이지 인쇄

Fitting Instructions

The following instruction is for installation of the right-hand side Power Board.

Follow same instructions for installation of left-hand side Power Board.

IMPORTANT

Clearview recommends this installation to be completed by a professional. Incorrect

installation may cause damage to your vehicle and possible personal injuries.

Step 1

Installation of wiring

1.1 Remove Fuse from Positive (Red) wire supplied and

connect wire to vehicle battery positive (+) terminal.

Ensure connection is secure.

1.2 Route Power Wiring from Battery in Engine Compartment, then

feed the white plug through the firewall of vehicle through rubber

grommet bringing the white connector to Passenger (Left) side

footwell.

Plastic wire feeder may be required for this step and subsequent

steps.

1.3 Route RF (Right Front) & RR (Right Rear) door

sensor wire connectors under the vehicle dash and

bring them across from passenger side to the

driver side.

Remove interior trim on Driver side B pillar and

C pillar to expose the vehicle door sensor

connectors.

Connect RF (Right Front) door sensor wire to

connector found behind B pillar, and then RR

(Right Rear) door sensor wire to connector

found behind C pillar.

Remove passenger side B pillar and C pillar

trims and REPEAT same process for LF (Left

Front) & LR (Left Rear) door sensor wires.

clearviewaccessories.com.au