ClearView HD168Bi 사용자 설명서 - 페이지 5
{카테고리_이름} ClearView HD168Bi에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView HD168Bi 10 페이지. Quad cvbs/hdmi hd encoder modulator
ClearView HD168Bi에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)
페이지 인쇄
2. INSTALLATION
2.1 What's in the Box
One HD168Bi Encoder / Modulator
One power cable
2.2 Connection
The HD168Bi unit comes standard with 4 x CVBS and HDMI inputs.
Use a quality 75Ω coaxial cable with "F" connectors from the unit's RF OUT jack to the
distribution system or directly to a television.
Connect the power cord to an appropriately rated AC power outlet.
Once connected to power, the device turns on and it takes about 80 seconds to be
operational. Then the message "Initial Please wait" appears on the display. After 80 seconds
the message "CLEARVIEW and the Frequency Out" will be displayed.
CLEARVIEW
627.500MHz
2.2.1 DEVICE Programming and Setup
Connect an Ethernet cable directly (no Cross Over cable required) to the Ethernet Port
on the rear panel of the encoder and then connect the Ethernet cable to an Ethernet switch
or connect an Ethernet Cable to your PC. The default IP address is 192.168.1.138
Make sure your PC has the same first 3 IP sections, eg. 192.168.1.xx and the 4
from 138.
th
is different
HD168Bi Manual Rev 1.0