ClearView HD4660 사용자 설명서 - 페이지 13
{카테고리_이름} ClearView HD4660에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView HD4660 15 페이지. Dvb-t hd modulator
페이지 인쇄
5 MODULATOR CONFIGURATION VIA FRONT PANEL LCD
5.1 Once connected to power, the device turns on and it takes about 20 seconds to be operational.
Then the message "Initial Please wait" appears on the display. After 60 seconds the message "Status
(Enter) & IP Address 192.*.*.*" on the display.
Screen Views(5.1)
S t a t u s
( E n t e r )
1 9 2 . 1 6 8 . 1 . 1 3 8
5.2 Access the Edit Menu first enter the password by pressing the left & right key button.
5.3 Press the Enter button firstly, and then press right button to enter the password 0000.
5.4 Press Enter button again after display show Network Edit .
5.5 Use the Right/Left buttons to display Network Edit, CH&Enc Edit, RF Edit, Load Default, Chang
Password Mode selection.
5.6 Network Edit Menu : Use the Right/Left buttons to display Country, Original Net ID, Network ID,
Network Name, TS ID mode selection.
Screen Views(5.3 & 5.4)
5.7 CH&Enc Edit Menu: Use the Right/Left buttons to display Name, Service ID, LCN, on/off, Video
output, Audio output, Video Input, Input Video, Status , PMT, Video PID, Audio PID mode function.
5.8 RF Edit Menu: Use the Right/Left buttons to display Frequency, Constellation, Guard Interval,
Code Rate, FET Carrier, Bandwidth, RF Power, RF ON/OFF mode selection.
Screen Views(5.7)
C H & E n c
E d i t
5.9 Reset the Encoder/Modulator to back the factory default via pressing the Enter button to access
the Load Default page. Then, using the right/left button select YES to reset all programmed
settings back to the factory default setting.
Screen Views(5.9)
L o a d
D e f a u l t
5.10 Change Password Menu: Use the Right/Left buttons & Up/Down to select new password.
Screen Views(5.2)
E d i t
( E n t e r )
1 9 2 . 1 6 8 . 1 . 1 3 8
Screen Views(5.6)
N e t w o r k
E d i t
Screen Views(5.8)
R F
E d i t
Screen Views(5.10)
C h a n g e
P a s s w o r d
12
HD4660 Manual Rev 1.0