ClearView HD4660 사용자 설명서 - 페이지 5

{카테고리_이름} ClearView HD4660에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView HD4660 15 페이지. Dvb-t hd modulator

2. INSTALLATION

2.1 What's in the Box

One HD4660 Encoder / Modulator

One power cable

2.2 Connection

The HD4660 unit comes standard with HDMI, Component, and Composite video inputs.

Component Connection: Connect the Y (Green), Pb (Blue), and Pr (Red) video source cable

to the unit's Component input ports. If using a Composite Video source, use a 75Ω coaxial

cable with RCA connectors to connect the video source to the unit's CVBS port.

Use RCA cables to connect the audio source to the red / white AUDIO L and AUDIO R

INPUT jacks.

Use a quality 75Ω coaxial cable with "F" connectors from the unit's RF OUT jack to the

distribution system or directly to a television.

Connect the power cord to an appropriately rated AC power outlet.

Once connected to power, the device turns on and it takes about 20 seconds to be

operational. Then the message "Initial Please wait" appears on the display. After 60 seconds

the message "Status (Enter) & IP Address 192.*.*.*" on the display.

2.2.1 DEVICE Programming and Setup

Connect an Ethernet cable directly (no Cross Over cable required) to the Ethernet Port

on the rear panel of the encoder and then connect the Ethernet cable to an Ethernet switch

or connect an Ethernet Cable to your PC.

HD4660 Manual Rev 1.0