ClearView HD Cube Network Camera 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} ClearView HD Cube Network Camera에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView HD Cube Network Camera 20 페이지.

Speak or play music at the PC-end, you can use the built-in speaker of the device-end to listen.

Note

Please go to the Master Volume interface of the PC to set first if you want to use the dual-way

bidirectional talk. Please select Front Mic mode in the record control interface. (You can select

microphone enhanced in Advanced interface if the audio is too low.)

1.4 Alarm Setup

The alarm setup interface is shown as below. See Figure 1-3.

Figure 1-3

Please refer to the following figure for alarm input information. See Figure 1-4.

Alarm input: When the input signal is idle or grounded, the device can collect the different statuses of

the alarm input port. When the input signal is connected to the 3.3V or is idle, the device collects the

logic "1". When the input signal is grounded, the device collects the logic "0".

Figure 1-4

Please refer to the following figure for alarm output information. See Figure 1-5.

Port NO and Port C composes an on-off button to provide the alarm output.

This button is normal open. The button becomes off when there is an alarm output.