ClearView SD4250 사용자 설명서 - 페이지 10

{카테고리_이름} ClearView SD4250에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearView SD4250 13 페이지. Sd encoder and modulator ypbpr & cvbs to dvb-t digital rf

1. Model name SD4250; Frequency 473.500MHz

Encoder

2. Video in Status: User can enter the items respectively to view the video status.

3. Source: Select input source CVBS or YPbPr.

4. Video Bit Rate: Select bit rate range 4~12Mbps.

5. Adjust Color: User can adjust vales of items (Brightness & Contrast & Saturation & Hue: range 0~50).

6. Audio Bit rate: Select audio bit rate among 128, 256, 384 kbps.

Stream

7. TSID: (Transport Stream ID) range: 0~65536,

8. NIT: (Network Information Table) NIT table is a very important table for describing the network and TS.

User can view or adjust after enter this menu.(ONID: (Original Network ID) & Network ID & Network Name

& Network Ver )

9. Service Name: User can view or adjust after enter this menu.

10. LCN: User can enter the submenus displayed and edit the values or select the LCN (Logical channel number),

(Australia, New Zealand: range 1 ~ 16383, Europe: range 1 ~ 1023)

11. PID: User can view or adjust after enter this menu. (PMT PID & PCR PID & Video PID & Audio PID)

12. Rtrv Status: User can check the settings.( PID, Port Number, TS ID, Origin Network ID, Network ID, Network

Name, Network Version, Service Name, LCN, PMT PID, PCR PID, Video PID, Audio PID, Private Data)

Modulator

13. Country: Select your region. (Australia, Europe, New Zealand)

14. Channel: User can view or adjust after enter this menu.(RF Frequency & RF Level & RF Level & FET &

Constellation & FEC & Guard Interval)

System

15. Rtrv Inventory: It displays the version information of this device. SW: software version number; HW:

hardware version number. User can also press ENTER again to view the published time of this device.

(HW: 1.00, SW: 1.00, May. 07, 2015)

16. Factory Default: Reset Mode: Hard Reset (reset all sets) or Reset to Default (reset to the factory's default

configuration).

17. Upgrade Code: User can upgrade software by press ENTER button. It will show "Upgrade Software Please

wait...", when the device is upgrade. When it is done, it will show "Upgd Successfully Any key to reboot" on

the display.

18. IP addr: User can view or adjust after enter this menu. (Enable DHCP & IP Address & Network Mask &

Default Gateway)

19. Read IP Setup: User can check the settings after enter this menu. (IP ADDR & NET MSK & MACADDR)

20. Language: User can view or adjust after enter this menu. (This model provide English version only.)