EdgeWave iPrism 랙에 설치 - 페이지 3

{카테고리_이름} EdgeWave iPrism에 대한 랙에 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. EdgeWave iPrism 3 페이지. Models 15h;models 25h;models 35h;models 55h; models 105h;
EdgeWave iPrism에 대해서도 마찬가지입니다: 하드웨어 매뉴얼 (12 페이지)

페이지 인쇄

Figure 3: Installing the Server into a Rack

Installing the Server into a Telco Rack

To install your St. Bernard Server Appliance into a Telco-type rack, use two L-shaped brackets on either side of the chassis (four total). First, determine how far

the server will extend out the front of the rack. Larger chassis should be positioned to balance the weight between front and back. If a bezel is included on your server,

remove it. Then attach the two front brackets to each side of the chassis, then the two rear brackets positioned with just enough space to accommodate the width

of the Telco rack. Finish by sliding the chassis into the rack and tightening the brackets to the rack (see Figure 4).

Figure 4: Installing the Server into a Telco Rack