Altrason Humidry BIF-220V 사용자 설명서 - 페이지 6

{카테고리_이름} Altrason Humidry BIF-220V에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Altrason Humidry BIF-220V 13 페이지. Ceiling mounted desiccant rotor multifunctional dehumidifier
Altrason Humidry BIF-220V에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)

Smart
Room Heating
For BRA, BRB, BRC Series
Cool Air
Dehumidification
For BRA, BRB, BRC, BRF Series
Enhanced
Dehumidification
For BRA, BRB, BRC Series
Air Circulation –
Vent Air or
Air Ventilation
For BRA, BRB, BRC, BRF Series
Function/Controls
Press the "Smart Room Heating" button to start sending warm air
into the room.
Unit will stop at the end of the default running time of 1 hour.
Press the left or right button to change the run time. There are 5
preset selections of 1, 1.5, 2, 2.5, and 3 hours.
Pressing the Power Off button to stop unit operation.
Refer to page 2 for more information on operating Smart Room
Heating.
After pressing the "Cool Air Dehumidification" button, the unit will
calculate the optimal humidity level based on the conditions indoors
and operate until the goal is reached. During dehumidification, the
room temperature will stay constant.
Default is set to auto, under which the unit will go into monitoring
once the target is reached. Dehumidification restarts automatically
when indoor conditions change.
Press the left or right button to change the run time. There are 5
preset selections of 1, 2, 4, 8, and 12 hours.
Pressing the Power Off button to stop unit operation.
After pressing the "Enhanced Dehumidification" button, the unit will
calculate the optimal humidity level based on the conditions indoors
and operate until the goal is reached. During dehumidification, the
room temperature will raise slightly.
Default is set to auto, under which the unit will go into monitoring
once the target is reached. Dehumidification restarts automatically
when indoor conditions change.
Press the left or right button to change the run time. There are 5
preset selections of 1, 2, 4, 8, and 12 hours.
Pressing the Power Off button to stop unit operation.
Refer to page 2 for more information on operating Enhanced
Dehumidification.
After pressing "Air Circulation" button, press the button again or use the
up/down buttons to switch to Ventilation. Stale, stuffy and humid air is
drawn outside the room via exhaust ducts to improve indoor air quality.
Default is set to run continuous (24 hours non-stop).
Press the left or right button to change the run time. There are 5 preset
selections of 1, 2, 4, 8, and 12 hours.
Pressing the Power Off button to stop unit operation.
Ensure that air can flow inside. Open the door slightly if you have to.