ClearWater AQUA ELITE 50 설치 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} ClearWater AQUA ELITE 50에 대한 설치 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater AQUA ELITE 50 20 페이지.

N). PROPER PROCEDURES OF MAINTAINING A HEALTHY POOL

An occasional oxidizer is necessary to burn off body oils, suntan lotions, and particles that get into the water and can cause

cloudiness. Always add an oxidizer whenever the water loses its "sparkle." Don't wait for the water to get cloudy, or an extra

dose will be required.

There are several oxidizer options:

Non-chlorine shock - Add one (1) pound of potassium monopersulfate (non-chlorine shock) per 10,000 gallons once a week

during the warm weather season, less frequently during the cooler weather, or when the water loses its "sparkle." You may

also want to add some non-chlorine shock after a rainstorm if the pool was left uncovered. These are available in most pool

stores, or at Leslie's Swimming Pool Supplies (1-800-537-5437) ask for "Fresh 'N Clear".

Household bleach - Add two (2) quarts of regular household bleach per 10,000 gallons once a

week. You may also use liquid chlorine – but only ½ the amount. This small amount will

dissolve rapidly and you will have chlorine-free water in a few minutes.

Tablet in skimmer - Add a 3" Trichlor tablet in the skimmer for continuous oxidizing. The

reading will be so low that it won't be detectable. This is ideal for pools with heavy swimmer use

or if the homeowner is away often.

WARNING: Excessive amounts of Copper may cause staining of pool and spa

surfaces. Always keep pH under 7.8 at all times.

O). CLEANING AND/OR REPLACING ELECTRODE

The only part of the Aqua Elite 50 that will need maintenance or replacement is

the electrodes. They should last about 1-5 years depending on your pool size,

length of swimming season, water temperature and how well the water was

balanced (ion level, pH, etc.). If the LED light "Check Electrode" comes on, it

may be time to clean or replace the electrode. To inspect the electrodes, simply

unscrew the electrode chamber with your hands and visually inspect the

electrode bars. A blue greenish coating is normal, however, if there is a heavy

buildup, you may need to clean the electrode. Using an old toothbrush and

lemon juice or a muriatic acid/water solution, scrub the buildup off the

electrode. If the electrodes are thin and worn out, they will need to be replaced.

Electrode Reordering Information:

Replacement Electrode - Part # CLE-02 - residential copper electrode for the Aqua Elite 50 Model.

Always add more teflon tape when screwing the electrode back into the flow-cell tee.

Adding an Occasional Oxidizer