Altrason Humidry BRC-110V 사용자 설명서 - 페이지 7
{카테고리_이름} Altrason Humidry BRC-110V에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Altrason Humidry BRC-110V 13 페이지. Ceiling mounted desiccant rotor multifunctional dehumidifier
Altrason Humidry BRC-110V에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)
페이지 인쇄Air Circulation – Indoor
Air or Air Recirculation
For BRA, BRB, BRC, BRF Series
Wall
Panel
Smart
Clothes Drying
For BRA, BRB, BRC Series
Power Off/ Settings
For BRA, BRB, BRC, BRF Series
Wall Panel
Remote
Control
・
After pressing "Air Circulation" button, press the button again or use
the up/down buttons to switch to Re-Circulation. Air circulates
continuously inside.
・
Default is set to run continuous (24 hours non-stop).
・
Press the left or right button to change the run time. There are 5 preset
selections of 1, 2, 4, 8, and 12 hours.
Remote
Control
・
Pressing the Power Off button to stop unit operation.
・
After pressing the "Smart Clothes Drying" button, the unit will
calculate the optimal humidity level based on the conditions indoors
and commence clothes drying. Room temperature will rise during
clothes drying.
・
Default is set to auto, under which the unit will go into monitoring once
the target is reached.
・
Press the left or right button to change the run time. There are 5
preset selections of 1, 2, 4, 8, and 12 hours.
・
Pressing the Power Off button to stop unit operation.
・
It is advised that hand washed clothes are drained and spun for at
least 5 minutes before hanging to reduce the operation time of Smart
Clothes Drying.
・
Refer to page 2 for more information on operating Enhanced
Dehumidification.
・
Unit stops current action and goes into Powered Off after pressing
this button.
・
To enter the Settings menu, hold Settings button for 3 seconds. Use
the directional buttons to select and configure the unit as you desire.
Setting Item
Language
Humidity
Preference
Power Lost
Resume
Resume
to Auto
Description
English/ Traditional Chinese/ Simplified Chinese/
Japanese/ Korean
Lower/Normal/Higher. Default is set to "Normal".
Humidity Preference only applies to dehumidifica-
tion functions set to auto.
Yes/No. Default is set to "Yes". Activate this to allow
resumption of the unit's action prior to blackouts.
Yes/No. Default is set to "No". Activating this will
allow for the last auto dehumidification function to
resume in the event of switching between
functions, e.g., switching to Air Circulation function
during Auto Cool Air Dehumidification when
"Resume to Auto" is set to "Yes" will revert the unit
back to Auto Cool Air Dehumidification once the Air
Circulation job is finished.