EDI LMD224 운영 매뉴얼 - 페이지 6

{카테고리_이름} EDI LMD224에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EDI LMD224 14 페이지. Inductive loop monitor

페이지 인쇄

2.1 SET THE SENSITIVITY LEVEL

The DEFLECTOMETER

to the most optimum sensitivity level to ensure the detection of all vehicles, including

motorcycles and high bed vehicles.

 While the LMD Series unit is in the Call state (DEFLECTOMETER = 1-9), the

DEFLECTOMETER

increase or decrease one step as the Sensitivity Level is increased or

decreased one step.

 The Call Strength value will depend on the size and type of vehicle in the

detection zone as well as the Sensitivity Level setting of the channel. The

optimum value for a mid-sized vehicle is 5.

 The procedure in section 2.1.1 provides a quick and simple way to program

the Sensitivity Level to the optimum setting to ensure all classes of vehicles

are reliably detected with one simple step.

 The resulting Sensitivity Level can be then be displayed using the procedure

in section 2.1.2. While the LMD Series is in the No-Call state

(DEFLECTOMETER = 0), the DEFLECTOMETER

Sensitivity Level (1 – 9) when either SENS button is pressed once.

For typical vehicles (mid-size vehicle / small pick up) utilizing properly installed roadway

loops, when the Call Strength value 4, 5, or 6 (5 being optimum) is displayed on the

DEFLECTOMETER

correctly. For high profile vehicles (commercial trucks, 4x4's, etc...), a DEFLECTOMETER

Call Strength value of 4 will be best. For low profile vehicles (sports cars, etc...), a

DEFLECTOMETER

2.1.1 ADJUSTING SENSITIVITY USING THE DEFLECTOMETER

The DEFLECTOMETER

typical

mid-sized

DEFLECTOMETER will display the Call Strength value (1 - 9).

If a mid-size vehicle, located over the roadway loop causes the Call Strength value "7" to

be displayed on the DEFLECTOMETER

2 = DEFLECTOMETER reading "5"). This is done by pressing the front panel SENS

(down) button twice.

If a mid-size vehicle, located over the roadway loop causes the value "2" to be displayed on

the DEFLECTOMETER

DEFLECTOMETER reading "5". This is done by pressing the front panel SENS (up)

button three times.

NOTE: The DEFLECTOMETER

change, allowing changes to the Sensitivity setting while a vehicle remains in

the loop detection zone. Note that the Call Strength value may be different than

the actual Sensitivity Level setting.

Eberle Design Inc.

LMD222 and LMD224 Series

Operations Manual

Section 2

Installation and Adjustments

(front panel 7-segment LED display) aids in setting the detector

displays the Call Strength (1 – 9). The Call Strength will

during the DETECT output period then the sensitivity level is set

Call Strength value of 6 will be best.

should read zero (0) with no vehicle over the roadway loop. With

vehicle

the

, the sensitivity should be lowered two levels (7 –

, the sensitivity should be increased three levels (2 + 3 =

dynamically updates after each Sensitivity Level

detection

zone

(DET

will display the

(RECOMMENDED)

indicator

On),

Page 3

the