EDI ED400D-E-111-4D-N4-SR1 제품 설명서 - 페이지 2

{카테고리_이름} EDI ED400D-E-111-4D-N4-SR1에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EDI ED400D-E-111-4D-N4-SR1 5 페이지.

PRODUCT MANUAL

Unpacking Instructions:

A copy of these instructions is packed with each unit. Open carefully to avoid scratching the unit's

paint and plastic lens or cutting the line cord.

Mechanical Mounting Instructions:

This unit is equipped with two brackets attached to the back of the display for mechanical

mounting purposes. The unit is designed to be mounted to a wall.

Power Requirements:

This unit is equipped with a standard, eighteen-gauge, three-wire line cord that is designed to be

plugged into a standard, 120 VAC, 60 Hertz, grounded outlet. The maximum current draw for this

unit (at 120 VAC) is __1.3__ Amperes.

Power-up Response:

UPON POWER UP, THE UNIT WILL DISPLAY will scroll an power up diagnostic message. a

= 'XX' b = 'YY' p = 2; where 'XX' is the address of the display, 'YY' is the baud rate of the

display (Factory set to 1200), and p is the 2 digit addressing protocol.

See Dip Switch Settings for changing baud rate and address.

Dip Switch Settings:

This program selects display address, baud rate, type of display hardware, and

message protocol based on DIP switch settings. Figure 1 shows the general

layout of the 1700-259 CPU board on the back of the display and identifies the

'ADDRESS' switch and the 'FUNCTION' switch. The following pages detail the

purpose of each of these switches.

Figure 1

"FUNCTION" Switch:

"FUNCTION" DIP switches one, two, and three are used to specify the type of

display board that is being used. These switches were set at the factory and

should not be changed in the field.