EDI LMD622T-R 운영 매뉴얼 - 페이지 12

{카테고리_이름} EDI LMD622T-R에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EDI LMD622T-R 15 페이지. Deflectometer, inductive loop monitor

LMD622 and LMD624 Series

Operations Manual

circumference to prevent the loop wire from rising up while the sealant is poured and

curing.

Many different types of loop sealant are now available. Single part types are the easiest to

apply since no mixing is required, but they also tend to be more expensive in terms of linear

feet of saw slot filled. When applying the sealant, make sure that it is able to sink to the

bottom of the slot and completely encase the loop wire. The wire should not be able to

move when the sealant has set. Ensure that there is enough sealant to completely fill the

slot; if possible the sealant should protrude slightly above the surface of the pavement so

that small rocks or other debris cannot collect in the slot.

The sealant manufacturer instructions concerning setting time should be noted especially

when determining the length of time to wait before allowing vehicles to cross the loop area.

Consult the Eberle Design web site at

www.EDItraffic.com

for further application

information regarding loop design.

Eberle Design Inc.

Page 9