ClearWater clearspa 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} ClearWater clearspa에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater clearspa 8 페이지.

7. One end of the pipe will fit over the manifold and the other end will connect to

the non return valve. Both connections are secured by the Hose clips.

8. The non return valve is a safety feature. It stops any water travelling through

the remainder of the pipe and getting into the motor. For this reason the valve

must be fitted the correct way. The air is allowed to travel through one end of

the valve and the non return is at the other end. The best way to test which end

is which is to blow through both ends. The valve has a spring end which lets

the air travel through this end must be fitted into the pipe that comes from the

motor. The picture below shows the connection between the manifold and the

9. You can now cut the required length which runs from your motor to the non

return valve. Once the length is cut place the remaining hose cuffs on the two ends

of the pipe. One end is fitted over the non return valve and secured by the hose

clip, the other end is fitted to the motor as shown below. We recommend that a

double loop is created in the hose to prevent water return. Please note that the pipe

from the motor to the valve in the picture is shorter for photography purposes.

Clearwater Clearspa Instructions 09/06

non return valve.

Section 3