ClearWater Lights Billie 운영 매뉴얼 - 페이지 8
{카테고리_이름} ClearWater Lights Billie에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Billie 12 페이지. Dimmable
페이지 인쇄
Clearwater Billie Brake Light Features & Operations
Step 1: Parts List and Bike Preparation
Inertial Braking Mode (CANopener Version 1.82+):
-Inertial Brake Mode 3a
will activate when the engine braking level reaches 0.2G. This will make the
activation of the brake light during engine braking happen more frequently,
under less deceleration.
Inertial braking is disabled during standard brake light mode (Brake Mode 2)
but works equally well using the California 4-flash (Brake Mode 3) or variable
flashing (Brake Mode 4) modes. In either of these modes, the brake light will
appear just as if the rider had engaged the brake, including the programmed
flashing and automatic brightness control.
Adding mechanical braking at some point during the engine braking
process provides seamless, uninterrupted action of the brake light.
Factory Reset Default:
To reset the CANopener to the factory settings, press and release the
TSC button, hold the turn signal to the left, then press and release the flash-
to-pass button 6 times within 6 seconds. Release left turn signal. All factory
preset dimmer levels and modes will be selected.
A successful reset is indicated by five flashes of the Clearwater lights.
Billie Indicator Light:
Included with the Billie Brake Light Kit is an optional feature that
allows the user to conveniently monitor what the Billie Brake Light is doing
while on the bike. The Indicator light is very simple to install. Fasten the LED
to an area that can be easily seen when riding, then route wiring to the
back of the bike near the CANopener. Next, the red and black wires from the
Indicator light will be Posi-Locked to the CANopener red and black wires,
along with the red and black wires from the Billie Brake Light. The image
below shows our recommended mounting location.
Page 8
(Default
Mode): High sensitivity mode. The brake light
Page 7