ClearWater Lights Krista 설치 매뉴얼 - 페이지 6
{카테고리_이름} ClearWater Lights Krista에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearWater Lights Krista 8 페이지. Kawasaki concours 1400 led light kit dimmable patent pending
ClearWater Lights Krista에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (12 페이지)
페이지 인쇄
Step 5: Wiring
Wiring Continued:
• Route the two black connectors for the lights to a convenient location
where they will not interfere with steering or any other moving parts.
• Install the switch in a convenient location. Refer to the sticker on the
switch for proper placement.
• Switch - Crimp spade lugs to red, yellow and black wires from relay
box. Attach to corresponding tabs on switch. (See wiring diagram)
• Using Posi-tap, attach red (turn on wire) to a switched 12v wire. See
wiring diagram for your motorcycle.
• Install connectors as shown in the wiring diagram on page 7.
• Note: extra crimp on connectors provided in connection kit for if you would
like to shorten the wires.
Horn Feature:
• Locate the Horn's hot (+) lead. This will make your lights flash to full
when you sound your horn. Use a Posi-tap to connect one of the white
wires from the relay box to this wire. It does not matter which white
wire you use, both trigger the same way. If you do not want to use this
feature, simply tuck the white wire away in a neat fashion.
High Beam Feature:
• If you are going to install the high beam feature (and we hope you do),
locate the high beam headlight wire. This will be on only when the high
beam is illuminated. This will trigger the volume control knob to control the
brightness of the lights. Connect the white wire from the volume control
knob to this high beam circuit wire. (See wiring diagram for details)
Signal for Optional High/Low Feature:
• On left side behind main
connector bundle are 3
relays. The rear relay is
high beam relay.
• Tap into the red/black
striped wire with Posi-tap
connector.
Page 6
Red/Black Striped Wire