EDI EDV225MPC-3L-N1-VT-IR 빠른 매뉴얼 - 페이지 2

{카테고리_이름} EDI EDV225MPC-3L-N1-VT-IR에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EDI EDV225MPC-3L-N1-VT-IR 3 페이지. Production scoreboard

converter and connected to the computer USB port. The red line is connected to 485

converter'+'terminal, the blue line is connected to 485 converter'-' terminal, and the black line is

connected to 485 converter'-'terminal.

The 4-core aircraft head is connected with AC 100-230V voltage.

3. Instructions for the Use of Remote Controllers

1. Select the window. Pressure Settings (SET) key to the window where you want to adjust the

display content (with flashing prompts). The order is planned output, actual output, rhythm time

and counting step. Rhythm time and counting step length are displayed only in the planned and

actual output windows when set.

2. Input data. Input 0-9999 data directly with 0-9 digital key. The beat time ranges from 0.1 to 999.9

seconds. The counting step is 1-99. When set, the data is preceded by a prompt N. That is to say,

"N = 12" indicates that the counting step is 12.

3. Data clearance. Pressure reset (REPEAT) keys indicate that the content of the flicker prompt

window is zeroed, and the data can be re-entered using the above method.

4. End the adjustment. Press the START/STOP button to stop the blinking of the display window,

indicating the end of the display adjustment.

5. Start-up counting of planned output: In the unset state, press the WORK key, and automatically

add one planned output every other beat time. At this point, the last decimal point of the planned

output window flickers.

6. Planned output pause counting: Press the rest (REST) button and count the planned output

pause in the non-set state. At this time, the last decimal point of the planned output window is not

bright.

7. Increase the actual output step. Press the actual output plus (UP) key and increase the actual

output value by one step.

8. The actual output will decrease step by step. By pressing the DOWN key, the actual output value

is reduced by one step.

9. The actual output is zero. Pressure reset (REPEAT) bond under unset condition, the actual output

value is 0.

10. Set up the communication address. Press address (FGB) key, communication address two digits

flicker; press digital key input new communication address code, value range 1-99, if 10, press 1, 0