ArtFox SKY BEAM 9R 사용자 설명서 - 페이지 5
{카테고리_이름} ArtFox SKY BEAM 9R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ArtFox SKY BEAM 9R 16 페이지.
페이지 인쇄equipments, clamps, wirings and other additional fixtures.
equipments, clamps, wirings and other additional fixtures.
Screws for clamping must be fixed firmly. Take one M12 screw (Grade 8.8 or higher) to
mping must be fixed firmly. Take one M12 screw (Grade 8.8 or higher) to
mping must be fixed firmly. Take one M12 screw (Grade 8.8 or higher) to
clamp bracket, and then screw the nuts.
clamp bracket, and then screw the nuts.
Level the two hanging points at the bottom of clamp. Insert fastener to the bottom, lock the
Level the two hanging points at the bottom of clamp. Insert fastener to the bottom, lock the
Level the two hanging points at the bottom of clamp. Insert fastener to the bottom, lock the
two levers by 1/4 rotating clockwise; then install another clamp.
two levers by 1/4 rotating clockwise; then install
Install on safety string which stands at least ten times weight as equipment. Terminal of the
Install on safety string which stands at least ten times weight as equipment. Terminal of the
Install on safety string which stands at least ten times weight as equipment. Terminal of the
accessory is designed for clamps.
accessory is designed for clamps.
Make sure pan/tilt lock unlocked or not. Keep the distance more than 1M from equipment to
Make sure pan/tilt lock unlocked or not. Keep the distance more than 1M from equipment to
Make sure pan/tilt lock unlocked or not. Keep the distance more than 1M from equipment to
flammable material or lighting source.
ighting source.
Figure 2 Installation
Page 5