ArtFox ATMIC 3000 사용자 설명서 - 페이지 4

{카테고리_이름} ArtFox ATMIC 3000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ArtFox ATMIC 3000 7 페이지.

ATMIC 3000

There are 2 different models of

lamp: Philips XOP7-OF and XOP 15-OF.

XOP-7 models for AC 90-120 volts AC, 200 volts for the following; XOP -15 models for AC AC

from 200 to 260 volts for 200 volts or more.

WARNING: Installing any other lamp may cause damage or may damage the

lamp Insurance

Important: Please use the bulb from the factory.

Replacement lamp

After the lamp cover with a green LED light bulb can tell you the last life; If the LED is not

bright, but light bulbs flashing, on behalf of the lamp has been aging; If the LED is not flashing,

the control signal may be a problem.

Replacement lamp

Warning: Check the lights before opening the front cover is off the power!!!

1. Before demolition of the lamp, wait 1 minute, so that the residual PCB board capacitance

electric charge electric shock.

2. Light body to be cooled down before open the lamp cover.

3. Make sure the power is disconnected

4. Please lamp disassembly required

Control operation

This section tells how to do ATMIC 3000

Data connection

ATMIC 3000

to provide the data connection 3-pin and 5 pin socket outlet in all the output

pin 1 ground protection, pin 2, then negative, then positive pin 3. There is no connection 4-pin

and 5 pin. Connection, data transmission is to use a data input line and a data output line. Data

cable connection

1. DMX signal input connector of the controller can use 3-pin or 5-pin socket.

2. Connect to the last one in the M-3000 plug the output of a signal termination to avoid signal

reflection interference.

Device attachment

·RS-485 device using a shielded twisted pair: standard cable in the long run, cannot guarantee

the reliability of data transmission control. 24 type cable for the 300 meters run. Long distance

running in the recommended installation of a large cable or signal amplifier.

·Output signal lines do not split into two signal lines output.

·Not to overload the connection. A signal line can connect a maximum of 32 ATMIC 3000 lights.