EDIATec ECW100 설치 매뉴얼 - 페이지 13
{카테고리_이름} EDIATec ECW100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EDIATec ECW100 14 페이지. Collision warning unit
EDIATec ECW100에 대해서도 마찬가지입니다: 운영 매뉴얼 (15 페이지)
페이지 인쇄
13. Technical Data
The following data are provided without guarantee and may be altered at any time
without notice.
Height:
Width:
Length:
Weight:
Power supply:
Power drain:
Serial data:
GPS:
Radio:
Temperature:
Intercom:
Vibration:
Country of Origin: Switzerland
DECLARATION OF CONFORMITY
EDIATec
GmbH,
Switzerland declares that in typical configuration the
"ECW100 Collision Warning Unit" meets the requirements of
the CE Mark. The radio conforms to the requirements of EN
300 220-3:2000 (Power Class 9.The EMC conforms with EN
301 489-3:2002-08 for a Class 3 SRD Device (equipment
type I). ECW100 is a Class 1 item of radio equipment as
defined by R&TTE Directive.
Thun, February 2007
61 mm
61 mm (without M2.5 screws on bough sides)
95 mm housing (behind instrument panel, without connectors),
105 mm total length (incl. button and connector)
190 g (without radio antenna, without GPS-Antenna, without cable)
external power supply from 8.0 up to 26.0 V DC
(peak voltage up to 28.0 V DC)
recommended value 12 V DC, direct galvanic link to aircraft battery
via an essential 1 AT circuit breaker; this must be separate from
other essential aircraft power systems
ECW100 has reverse polarity protection
typically approx. 60 mA at 12 V DC (normal operation without
warnings or external display), a collision warning may double these
values
bi-directional RS232, compatible with NMEA-0183 Version 2.0,
standard message format GPRMC, GPGGA, data rate 4.8 to 57.6
kBaud, additional NMEA proprietary sentences PFLA and PGRMZ
(described in a separate document)
16-Channel WAAS/EGNOS compatible GPS engine, external 50 Ω
active antenna with 5 m 50-Ω-RG-174/U cable, MCX connector, 3.3V,
dimensions depending upon the antenna used, usually rectangular
45x45 to 50x50 mm, oval or circular of approx. 12 mm thickness.
SRD-F-Band 868.0 to 868.6 MHz (Europe), other frequencies
depending upon configuration less than 1 % duty cycle, peak pulse
power 10 mW (ERP), external radio antenna (λ/2 Dipole)
(screw-fitted to conventional SMA connector)
range approx 2 km, possibly up to 5 km, depending upon antenna
and installation
Operation: -10°C to +60°C, storage: -20°C to +70°C,
no certification in accordance with DO-160E Sections 4 and 5
signal to intercom, radio or head set, max. 1 V
Use in conditions of strong vibration or turbulence should be avoided
or subsequently checked prior to continued operation,
no certification in accordance with DO-160E Section 8
Im
Baumgarten
10,
3600
Thun,
Page 13