Edic GALAXY 소유자/운영자 매뉴얼 - 페이지 8

{카테고리_이름} Edic GALAXY에 대한 소유자/운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Edic GALAXY 19 페이지. Professional 12 gallon carpet extractor

Edic GALAXY 소유자/운영자 매뉴얼
PRIMING THE MACHINE USING THE
PRIMING HOSE:
1
1. Locate your priming hose (pictured above). Your
priming hose can be found in the solution tank of
your new machine when you first receive it.
2. Make sure that your solution tank has a good
amount of water, as this will help the pump prime
more easily. (Solution tank is #3 on page 6)
3. Connect the female end (#3 on image above) of your
priming hose to the male fitting on your extractor.
(#7 on page 6)
4. Hold the plug end (#2 on image above) to the vacu-
um inlet barb (#5 on page 6).
5. Turn on your pump and vacuums.
6. Let the machine run until you can see bubble free
water flowing through the clear priming hose (#1 on
image above).
7. Turn off pump and vacuum(s)
8. Your pump is primed and ready to start cleaning.
9. Disconnect priming hose and connect either your
heater hose or your 25ft solution hose.
2
3
ADJUSTING PRESSURE USING THE
PRESSURE REGULATOR:
Pressure gauge
This machine is equipped with a PRESSURE REGULA-
TOR and PRESSURE GAUGE. You may adjust the pres-
sure between 100PSI and 250PSI. The machine has been
set to the max pressure at the factory. DO NOT exceed
250PSI. For location of pressure gauge and regulator, see
#8 & #9 on page 6.
TO REDUCE PRESSURE:
1. Turn on the pump. Prime, if necessary.
2. DO NOT SPRAY WHILE ADJUSTING.
3. Turn the PRESSURE REGULATOR counter-clock-
wise and monitor the PRESSURE GAUGE until you
have reached the desired Pressure.
TO INCREASE PRESSURE:
1. Turn on the pump. Prime, if necessary.
2. DO NOT SPRAY WHILE ADJUSTING.
3. Turn the PRESSURE REGULATOR clockwise and
monitor the PRESSURE GAUGE until you have
reached the desired Pressure.
**WARNING: DO NOT EXCEED 250PSI! MOTOR
MAY BECOME DAMAGED.**
8
Pressure regulator