Clearwell Mobility Admiral Mk3 사용자 설명서 - 페이지 8

{카테고리_이름} Clearwell Mobility Admiral Mk3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clearwell Mobility Admiral Mk3 16 페이지.

Battery Charging

Charging Socket

The charging socket should only be used for

connecting the scooter battery charger plug to

the scooter. The charging socket should not be

used to supply power for any other device.

Connection of unapproved electrical devices may

damage the control system or compromise the

EMC performance of the scooter.

Charging

Socket

Always put the socket cover back over the

charging socket when the battery charger has

been removed.

Connecting the Charger and Charging

Ensure the scooter is switched off and connect the charger to the scooter. Then,

connect the charger to the mains supply by means of the mains plug and switch on.

The red light will illuminate to show that the power is on.

If the red light flashes there is a fault - contact Clearwell Mobility.

The yellow light will illuminate to show the batteries are charging.

The yellow light flashes to show incorrect or no battery connected.

The green light will illuminate when the charge cycle is complete.

Always leave the charger on for a full cycle of 8-10 hours before disconnecting. This

should be done even if the charger indicates full charge.

WARNING: The charger is designed for indoor use. Do not use outdoors or expose to

rain, snow, spray or moisture.

When the scooter is not to be used for a long period of time, first charge the batteries

fully and then disconnect them from the scooter. Store as close to room temperature as

possible.