ARTFOX Lighting LED Beam Wash 19E 사용자 설명서 - 페이지 2
{카테고리_이름} ARTFOX Lighting LED Beam Wash 19E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARTFOX Lighting LED Beam Wash 19E 8 페이지.
페이지 인쇄TABLE OF CONTENTS
1. Safety Instructions ................................................................................................... 2
2. Technical Specifications ......................................................................................... 4
3. How To Control The Unit ..................................................................................... 6
4. shape ...................................................................................................................... 13
5. Trouble shooting ................................................................................................... 15
6. Fixture Cleaning .................................................................................................... 16
statement
The
product
has
well
capability
factory. All of the user should comply with warning item and manual, any
misuse cause of the damages are not included in our guarantee, and
also can not be responsible for any malfunction & problem owing to
ignore the manual.
1. Safety Instructions
Please keep this User Guide for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using
the unit.
Before operating, ensure that the voltage and frequency of power
supply match the power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order
to avoid electric shock.
and
intact
packing
when
leave
5. Trouble shooting
Following are a few common problems that may occur during operation. Here are
some suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
2. If the DMX LED is on and no response to the channel, check the address
settings and DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or on
PCB of the unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that
may cause damage or interference to DMX interface circuit.
C. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is
broken.
2. The motor's drive IC on the PCB might be out of condition.
2
15