Edic Endeavor 9000I-HSH 빠른 매뉴얼 - 페이지 10

{카테고리_이름} Edic Endeavor 9000I-HSH에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Edic Endeavor 9000I-HSH 15 페이지.

VACUUM:

Before Using the Vacuum, first connect your vacuum hose to the hose barb connector on the machine as well as your

floor tool (carpet wand, REVOLUTION, upholstery tool). Then turn on the vacuum motor by placing the vacuum (VAC)

switch, located on the front panel, in the ON position.

PUMP:

Before turning on the pump, make sure your solution line and working tool are connected to allow spraying. To turn the

ENDEAVOR's pump on, locate the pump switch on the front panel and place it in the ON position. If your pump needs to

be primed, please see priming and pressure relief section. Never leave the machine unattended in the "P" position to

prevent flooding or loss of solution.

REGULATING PRESSURE:

To regulate pressure, locate the regulator on the front of the machine and turn the pump switch into the on position. Turn

the regulator counter-clockwise to reduce pressure and turn clockwise to increase pressure.

Do not regulate above 1100PSI. Do not regulate while spraying.

Make sure you have set the pressure appropriate for the particular job you are

performing.