Cleaver CDAOX388 사용자 설명서 - 페이지 7
{카테고리_이름} Cleaver CDAOX388에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cleaver CDAOX388 16 페이지. Dry ageing cabinets
페이지 인쇄
3. Built-In Installation
Underbench Installation of The Bullock
•
Our CLEAVER Dry Ageing Cabinets are front venting but are not designed
to be fully integrated behind a joinery door.
•
Please follow the installation diagrams (page 5 and 6) when installing
built-in CLEAVER Dry Ageing Cabinet ensuring no less than the minimum
installation dimensions.
•
The Cabinet will draw air from right of ventilation frame and expel
through left of ventilation frame under the front door.
•
The power cord is 2.0m in length and is fixed on the right side at the back
when looking from front of cabinet.
•
In warm climates extra ventilation is required. An air vent or grid, 200mm
x 40mm, MUST be cut out at the rear top of the back partitioning or at the top
of either side of the partitioning, allowing air around the rear of the cabinet.
•
This air vent or grid must not open on the same side as other appliances
such as ovens, or an area that is sealed and without access to fresh cool air.
Failing to comply with the above specifications could result in the cabinet
overheating and voiding the warranty.
4. Before Turning Your Cabinet On
Before Using Your CLEAVER Dry Ageing Cabinet
•
Remove the exterior and interior packing.
•
Select an appropiate location for the cabinet which is;
- Well ventilated
- Away from heat sources and direct sunlight
- Not too damp
- At least 1 metre away from a microwave oven
•
We recommend fitting a surge protector to the power outlet.
•
Level your CLEAVER Dry Ageing Cabinet using the 4 adjustable feet. We
recommend setting the rear feet first and then adjusting front feet to level
your cabinet.
•
Before connecting CLEAVER Dry Ageing Cabinet to the power source, let
the cabinet stand upright for at least 3 hours. This will reduce the possibility
of a malfunction in the cooling system as a result of transportation.
•
Clean the interior surface with lukewarm water and gentle detergent and
a soft cloth.
•
Remove any factory smells in the cabinet by spraying the internal services
with a solution of 2 tablespoons of baking soda dissolved in one litre of water.
Leave on surfaces and wipe clean after 24 hours.
7