EDIC-mini CARD24S 운영 매뉴얼 - 페이지 4

{카테고리_이름} EDIC-mini CARD24S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EDIC-mini CARD24S 8 페이지.

Since the Recorder needs some time to close the recorded file (about 3 seconds), the red LED will be

indicating this process and stating the card can't be removed. As soon as the LED goes off, the memory card

can be removed. Failure to do so may damage the recorded file.

If during recording free memory runs out and circular recording function is not enabled in the Recorder's

settings, the Recorder makes three flashes of the yellow LED, stops recording and switches to Standby mode.

Further attempts to enable recording (with circular recording turned off) will lead to triple flashes of the

yellow indicator stating there is no capacity on the memory card, and the Recorder will go to standby mode.

If during recording, battery charge level is too low, the Recorder stops recording, closes current file and exits

operating mode.

Each time recording is enabled, a new file is created, the name of which corresponds to:

<EM_CARD24S_yyyymmdd-hhmmss_123_xxxxxx.wav>

Where: yyyymmdd - year, month and date of recording, respectively;

hhmmss - recording start time, hours, minutes and seconds, respectively;

123 - options for the recorded file:

1 - voice activation system (VAS): N - disabled, V - enabled;

2 - start recording by one of the timers: T - recording started by timer, M - recording was made in regular

mode;

3 - recording mode: L - linear recording mode, C - circular mode;

xxxxxx is a six-digit serial number.

Circular Recording

Use configuration file to enable and configure circular recording. If circular recording is enabled, after the

entire memory capacity is full, the oldest data are deleted to continue recording over the freed space.

File size restrictions can be activated and adjusted via configuration file. If during recording, file size exceeds

maximum permitted size, the file is closed and recording continues in a new file. If at the end of recording, the

recorded file is smaller than the minimum allowable size, it is deleted. Restrictions are operational only as

long as they are active. If the restrictions are off, files of any small size are saved in the Recorder's memory

card. Old file is closed and the recording continues in a new file only in case of file size approaching the level

of 2GB.

The Recorder switches from standby mode to playback mode by a short once pressing the PLAY button. The

Recorder starts playing back the last file recorded indicating battery charge level with periodic series of green

LED flashes.

• single flashes indicate the battery is fully charged;