dji E1200 Standart 사용자 설명서 - 페이지 6

{카테고리_이름} dji E1200 Standart에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji E1200 Standart 9 페이지.

페이지 인쇄

ESC

Before using the Updater, unplug any other serial devices that are connected to

your computer, then follow the instructions below:

1) Download the DJI ESC Assistant from the official DJI website. Run the installer

and follow the prompts to complete the installation process.

2) Connect one end of the Updater to the Data/ESC Firmware Update Port.

Connect the other end of the Updater to a PC with a Micro-USB cable. Turn on

the ESC system by connecting it to a 6S LiPo battery and do not disconnect the

ESC from the computer until the configuration is complete.

3) Run the DJI ESC Assistant software and wait for the ESC to connect to the

program. Watch the indicators at the bottom of the screen. When the ESC

has been successfully connected, the 'Computer Connection' status will be

solid green and the Data Exchange Indicator will blink blue.

4) Click the 'View' Tab. In the 'ESC' Section, check the current firmware version

and ensure that the installed firmware is up-to-date. If it is not, click the link

and follow the prompts to update it.

5) In the 'LED Color' Section, customize the colors of the ESC LED indicators.

If the ESC is not automatically recognized by the DJI ESC Assistant

(the indicators at the bottom of the screen will show a solid green and

inactive blue color if not connected), check whether there is more than

one DJI Updater, FTDI USB adapter or other developer tool (including,

but not limited to BeagleBone, Raspberry, Arduino, etc.), which may

use the FTDI chipset, connected to the computer. If any of these FTDI

devices are connected, simply unplug them and keep the DJI Updater

connected to the computer. Then, restart the DJI ESC Assistant and

the ESC system, and the two should connect.

8. ESC LED Indicators & Sound Definitions

The definitions are the same for both the outer ESC LED Indicators and inner

ESC LED Indicators, as shown below:

LED Indicators

Yellow-Green, blinking in turn

Red or Green, blinking slowly

—/

—

Solid Red or Green

Red-Yellow,

blinking in turn

Yellow, blinking quickly

Updater

Sound

None

1356

None

BB---BB---BB...

BBB----BBB...

BBBBBB...

Computer

Description

Motor is connecting

Ready

Motor has started normally

Self-test failure

Input voltage is abnormal

The motor's parameters

don't match the firmware

data saved in the ESC

Throttle stick is not at the

bottom position