Akku Power 7S2P 안전 지침 - 페이지 3

{카테고리_이름} Akku Power 7S2P에 대한 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Akku Power 7S2P 12 페이지. Li-ion dt2 battery, 25.2v / 9.0/5.0ah / 226.8/126wh, idex fire & safety
Akku Power 7S2P에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)

페이지 인쇄

• DO NOT short-circuit the battery pack. Make sure connections

do not contact metal objects, water, oil, jewelry, etc.

4. General precautions:

• Use battery packs only with IDEX Fire & Safety rescue tools

• Charge battery packs only with the specified IDEX Fire &

Safety battery chargers - Max. charge voltage: 29,0 V.

• After each underwater operation place the battery for at least

48h into a security container or secured area before next use.

• After an underwater operation the battery needs to be dryed

completely before charging. DO NOT use air pressure devices

to clean and dry out the contacts of the battery, as this may result

in damaging the sealings. Place the battery for 48h upside down

(contacts facing down) to dry out the battery.

• Under correct handling and storage the IP68 sealing is defined

with a product life span and IP68 compliance of maximum 4 years.

• Never try to connect the battery with the tool under water.

If this is not possible, as in cases of emergency, please proceed

contacting the battery under water to the tool and contact your

IDEX Service department after the rescue mission for further

assistance and support.

• DO NOT operate the battery beyond the defined limits of the

IP68 definition of the battery.

Always make sure that the battery is placed on the tool before

inmersing into the water.

• Disconnect the battery charger from a vehicle while unattended.

• To avoid overheating batteries, NEVER overcharge your device,

device, unplug when not in use.

• Maintain clean and open vent holes.

• DO NOT store or use the tool and battery pack in locations or

or vehicles where the temperature may reach or exceed 55°C

(131°F).

• Avoid explosive gases, open flames, direct sunlight or excessive

heat – risk of explosion.

• Children should be supervised to ensure that they do not play

with the appliance. This appliance can be used by children and

persons with reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they have been given

supervision or instruction concerning use of the appliance in a

safe way and understand the hazards involved.

• Cleaning and user maintenance shall not be made by children

without supervision.

• Persons who are not able to use the battery in a safe manner,

due to their physical, sensory or mental condition, or due to

their inexperience, must not use the battery charger without the

supervision or instruction from a skilled person.

• Strictly observe the minimum and the maximum charging

temperature. Contact with battery voltage may result in death

or serious injury.

• Make sure that during storage the battery pack is ideally

placed in a stable, and secured position that protects the pack

from unnecessary movements, avoiding contact with other

items or conductive materials, that may cause damages or

short circuits on the pack. If this is not guaranteed please re-

consider storing location of the battery pack or place the

battery in another position, that guarantees a stable and se-

cure position avoiding contact with other equipment and

therefore reducing the risk of any danger of physical damages

or short circuits on the pack.

• Make sure that while the battery is disconnected from the tool

or charger and carried by the tool operator that no conductive

conductive material such as, rings, bracelets, watches or remain-

ing liquids on the skin may come in contact with the positive and

negative pole on the pack, which may cause a short circuit and

burn signs on the skin or generate harmful electric shock for the

tool operator.

• Do not place the battery in aprons, pockets, tool boxes, product

kit boxes, drawers, etc...with loose nails, screws, keys, etc.

Transporting batteries can possibly cause fires if the battery

terminals inadvertently come in contact with conductive

materials, such as keys, coins, hand tools, etc...

• When transporting individual batteries, make sure that the

battery terminals are protected and well insulated from materials

that could contact them and cause a short circuit.