dji Matrice 200 Series V2 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} dji Matrice 200 Series V2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Matrice 200 Series V2 7 페이지. Manifold 2 mounting bracket
dji Matrice 200 Series V2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지), 사용자 설명서 (12 페이지), 제품 정보 (8 페이지)
페이지 인쇄
1.800.561.8187
Mounting the Intelligent Flight Batteries
Insert a pair of batteries.
Press once to check the battery level.
Press again and hold until the batteries turn on or off.
Only use battery slot B when using one battery to supply power. In this case, the aircraft can only be powered on, but cannot take off.
If for any reason only one battery is available during flight, land the aircraft immediately and replace the batteries as soon as possible.
Make sure to press the Battery Removal button when removing the battery.
Make sure to use the included TB55 batteries. DO NOT use any other type of batteries.
5. Flight
Toggle the Flight
Power on the remote controller,
Mode switch to
and aircraft.
P-mode, the safest
flight mode.
If using a CrystalSky Monitor, after the monitor is powered on, wait for a pop-up window that asks for a selection of USB device use, and then
select "DJI Pilot". Otherwise, the app cannot be connected to the remote controller.
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
OR
Combination Stick Command to start/stop the motors
Return-to-Home (RC)
Press and hold to initiate the RTH procedure. Press again to cancel.
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or
when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still spinning.
After landing, power off the aircraft before turning off the remote controller.
It is important to understand basic flight guidelines for the safety of both
you and those around you.
Refer to the Disclaimer and Safety Guidelines for more information.
www.
A
B
Ready to Go (GPS)
DJI Pilot
App
Before taking off, ensure that the Aircraft Status Bar in the
DJI Pilot app reads 'Ready to Go (GPS)' or 'Ready to Go
Launch the DJI
(Vision)' if flying indoors.
Pilot app.
Manual Landing
Pull left stick down (slowly)
until you touch the ground.
Hold for a few seconds to
stop the motors.
Left stick up
(slowly) to take off
To stop the motors mid-flight, press
the RTH button while simultaneously
pulling the left stick to the bottom inner
corner. Stop motors mid-flight will
cause the aircraft to crash. The motor
can only be stopped mid-flight when
the flight controller detects critical
error.
GEO Zones
.com
High
Low
7