Akku Power 7S3P 매뉴얼 - 페이지 6
{카테고리_이름} Akku Power 7S3P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Akku Power 7S3P 14 페이지. Li-ion dt2 battery, 25.2v / 9.0/5.0ah / 226.8/126wh, idex fire & safety
Akku Power 7S3P에 대해서도 마찬가지입니다: 안전 지침 (12 페이지)
페이지 인쇄All possible LED combinations are listed in table 2 to table 7
LED
LED
combination
combination
number
1
2
3
4
5
Table 2: State of charge (SOC) indicator during charging
When the battery is placed on the tool the SOC will be displayed once,
for approx. 60 sec.
During charging and discharging on the tool the SOC is permanently
displayed. Disconnected from the tool and charger the state of charge
(SOC) is displayed for 25 seconds after pushing the query button. The
SOC lights turn automatically off after the indicated time or by pushing
the query button again.
LED
LED
combination
combination
number
6
7
8
9
10
Table 3: State of charge (SOC) indicator on tool or stand alone
6
Description
Capacity = 100%
Capacity >=75%
Capacity >=50%
Capacity >=25%
Capacity < 25%
Description
Capacity >=75%
Capacity >=50%
Capacity >=25%
Capacity < 25%
Undervoltage
(fast blinking)
Charge Cycles
The number of charging cycles is shown when the button is pressed for at least 5s.
If you have activated the white LED already the cycles counts are not displayed. You
need to turn off the white LED before.
Cycle counts
LED
LED
combination
combin-
ation number
11
12
13
14
Table 4: Cycle counter indication
Separator code
LED
LED
combination
combin-
ation number
15
Table 5: Error indicator
The separator codes light up once after the cycle counts.
Error codes
The error codes are displayed after the error occurrence and will be
displayed until the query button is pressed again. The BMS will store
the last 3 error codes.
Description
Cycles = Cycles + number of blinks
Cycles = Cycles + number of blinks
x 10
Cycles = Cycles + number of blinks
x 100
Cycles = Cycles + number of blinks
x 1000
Description
Separator between cycle count and
fault memory indicator
5