dji MATRICE 300 RTK 유지 관리 매뉴얼 - 페이지 14

{카테고리_이름} dji MATRICE 300 RTK에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 300 RTK 19 페이지. Dual gimbal connector
dji MATRICE 300 RTK에 대해서도 마찬가지입니다: 제품 정보 (17 페이지), 유지 관리 매뉴얼 (19 페이지), 사용자 설명서 (15 페이지), 빠른 시작 매뉴얼 (10 페이지), 제품 정보 (10 페이지)

페이지 인쇄

MATRICE 300 RTK Maintenance Manual

Standard Charge and Discharge Operation Instructions

1. Charge the battery to 100% and leave the battery stationary for more than 24 hours.

2. Install the battery into the aircraft before flight. If the remaining power level is less than 20%, land

the aircraft and remove the battery.

3. Leave the battery stationary for more than six hours.

4. Charge the battery to 100% power level.

5. Repeat the above steps.

Battery Replacement Standard

1. The battery is visibly swollen, leaky, or damaged.

2. There is a prompt of battery cell damage or over discharge in the app.

3. The battery is rated for 200 cycles. It is not recommended to continue use afterward.

4. The battery error still exists after performing the standard charge and discharge operations twice

continuously.

Battery Disposal

1. Fully fill in an insulated bucket with 5% salt solution. Put the battery into it for more than 48 hours to

fully discharge the battery.

2. It is recommended to recycle the battery by a recycling agent to avoid environmental pollution.

Emergencies

1. Put out any battery fire using sand or a dry powder fire extinguisher.

2. Put the battery into 5% salt solution immediately if the battery shell has visible damage. DO NOT

use the battery afterward.

3. If any electrolytes make contact with your skin, immediately wash the affected area with clean

running water or alkaline hand sanitizer for at least 15 minutes. See a doctor immediately.

Warnings

1. It is recommended to charge and discharge the battery in a special explosion-proof cabinet.

2. DO NOT charge the battery near flammable materials, objects or on flammable surfaces.

3. DO NOT use the battery in a humid environment to avoid shot circuit.

4. Never disassemble or pierce the battery in any way.

5. Store Intelligent Flight Batteries in a well-ventilated and dry place.

6. Initial RTH immediately when the battery temperature is 80° C (176° F) or higher.

Vision System Calibration

Vision System calibration is required when any of the events below occurs.

1. The total flight time is 200 hours.

2. There is a calibration prompt in the app.