dji Matrice M210 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} dji Matrice M210에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Matrice M210 18 페이지. Matrice 200 series
dji Matrice M210에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지), 통합 매뉴얼 (20 페이지)

페이지 인쇄

Using Matrice 210/Matrice 210 RTK

1. Downloading DJI Assistant 2

Download and install DJI Assistant

http://www.dji.com/matrice-200-series

Ensure that the built-in DJI GO 4 app and DJI Pilot app are working normally. This manual uses the DJI GO 4 app as an example.

First-time activation requires your DJI account and an internet connection.

Internet

DJI Assistant 2 is only available for Windows 7 (or later) or OS X 10.11 (or later).

2. Charging the Batteries

Press the release button and open the corresponding charging port cover.

Insert the Intelligent Flight Battery into the charging port to begin charging.

Be sure to press the release button when removing fully charged batteries.

Using the IN2CH Charging Hub, charging time is

approximately 1 hour and 30 min (two batteries)*

DO NOT charge TB50-M200 and WB37 batteries simultaneously.

When charging is complete, the LED lights on the Intelligent Flight Battery will turn off, and the LED on the Charging Hub will turn solid green.

When charging is complete, the display on the remote controller will show 100%.

The Charging Hub will sound an alert when the battery has been fully charged. The alert can be turned on or off by toggling the switch under the hub.

Connect the Intelligent Flight Batteries to the aircraft and power them on. If battery temperature is lower than 15° C, the system will auto heat the batteries to maintain

a temperature between 15° and 20° C.

Pairing Intelligent Flight Batteries is recommended. This can be done with the DJI GO 4 app.

3. Preparing the Remote Controller

Mounting Monitor and Remote Controller Batteries

CrystalSky monitors and the Cendence remote controller

use the same batteries.

Put the battery into the Battery Slot, then slide it to the end

until you hear a click.

Press the Battery Release Button before removing the battery.

Press the Battery Level Button once to check the battery level.

Mounting the Monitor to the Remote Controller

Ensure that Part B is

unlocked. Connect Part

B to Part A.

2 on your computer via the website link below:

Charging Time:

Using the WCH2 Charging Hub,

2 hours and 24 min*

charging time is approximately

1 hour and 11 min (one battery)*

Lock the Mounting

Bracket.

Use a coin to adjust the

tightness of the tilt axis.

Power Outlet

100~240 V

(50Hz/60Hz)

*Provided charger

Low

High