Arthur Grillo DPC200-EP50 매뉴얼 - 페이지 4
{카테고리_이름} Arthur Grillo DPC200-EP50에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arthur Grillo DPC200-EP50 7 페이지. Differential pressure controller
페이지 인쇄
Mounting
The differential pressure controller DPC 200 is designed for wall mounting.
Installation must be done vertically.
The connection of the pressure lines is performed with plastic tubing, inner diameter ø5 mm and ø6 mm.
Device is position depended, therefore it is important that the assembly is vertical.
Operation
Start up:
- The device must be mounted vertically.
- All connections must be connected in accordance with this manual.
- The supply voltage must be controlled.
Factory setting in the delivered state:
The DPC200 is delivered with the following factory settings:
Operating mode:
Zero point:
End point:
Setpoint 1:
Setpoint 2:
Max. Voltage:
P-parameter:
I-parameter:
k-factor:
controlling mode:
measuring mode
adjusted to measuring range
adjusted to measuring range
about 75% of the measuring range
about 25% of the measuring range
maximum output voltage: 10,0 V
50
3,15
70
normal
4
T1 - Button 1
T2 - Button 2