AIMS Power PWRNV1250W 사용 설명서 - 페이지 6
{카테고리_이름} AIMS Power PWRNV1250W에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AIMS Power PWRNV1250W 9 페이지. Dc to ac power inverter
페이지 인쇄
•
Allow at least one inch of clearance around the Inverter for air flow. Ensure the ventilation
openings on the rear and bottom of the unit are not obstructed.
•
Do not connect the inverter directly to another AC power source. Damage may result, and
such damage will void the inverter warranty.
•
Know the wattage requirements of your appliance. Use only those appliances which are
limited by the capacity of this unit.
•
Use common sense. This device produces power just like your wall outlets at home and
should be treated seriously. Keep it away from children.
•
Reversed polarity of AC power outlet LINE /NEUTRAL will void the warranty.
•
If there is anything wrong with the inverter, disconnect all of the power and contact technical
support.
TROUBLESHOOTING
If the Inverter does not appear to be functioning properly, check the following possible causes:
•
Poor contact: Clean contact parts thoroughly.
•
If the low battery alarm sounds, this means the input voltage is too low and battery
needs to be recharged.
•
If you are getting a low output voltage, try reducing the load to minimize watts. You may have
overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to
maintain a constant flow of power.
•
If you are not getting any power output, turn the power switch Off and On again, until the
green power light comes on. Your devices may draw too much power to operate them. The
inverter may be in thermal shutdown. Let it cool down and make sure there is adequate
ventilation around the unit.
•
If the green light turns red one of the following has happened:
A. input voltage is too low
B. input voltage is too high
C. short circuit
D. inverter is close to overload
•
Battery voltage is too low: Start the engine to recharge the battery. Replace or recharge
battery if needed.
•
Shuts down on overload: Reduce the wattage of your load.
•
Thermal shutdown: Under heavy loads for extended period, the inverter will shut
down to prevent damage from excess heat. Simply reduce your load and allow the
Inverter to cool down.
•
Low-battery shutdown: Recharge your battery and resume operation.